Mayline 600 Series High-Back Chair Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
Item number: UL650HBLK
EXECUTIVE HI-BACK CHAIR
A. Remove all parts from carton and separate them into part number groups as indicated in parts list.
B. To begin assembly, place 5 star base (2) upside down and insert the casters (1) into bottom of the base (2).
C. Turn base (2) right side up on the floor and insert the gas lift (4) into center hole on the 5 star base (2).
D. Place telescoping cover (3) over the gas lift (4) and rest it on the base (2).
E. Push the back cushion up to a vertical position, and then put the chair on the floor as shown in Diagram 1. Lift up the
back flap (11), use 1-1/4” screws (10) to fasten the back support plate (12) to the bottom of seat cushion (7) and
tighten the screws, refer to Diagram 1.
F. Pull the back flap (11) tightly and attach the back flap (11) to the touch fastener on the bottom of seat cushion (7).
G. Attach the seat plate (5) onto the bottom of seat cushion (7)(with front of seat plate facing front of seat cushion) by
screwing 2-1/4” screws (8) into the front holes of seat plate (5) and 1” screws (9) into the rear holes of seat plate (5)
and tighten the screws, refer to Diagram 2.
H. Place the pre-assembled seat and back cushions w /arms (7) and seat plate (5) on top of gas lift (4) and press down
until fully engaged.
I. Tighten the screws on the arm to back by using the wrench (13), and then put the plastic covers (6) in the arm holes.
J. Periodically (every 90 days) make sure that the screws are still fully tightened.
ATTENTION: Make certain all screws are fully tightened before using chair.
Item # Description Quantity Part #
1.
2.
3.
4.
5.
6
7.
8.
9.
10.
11.
12.
13.
H.
Casters
5 Star Base
Telescoping Cover
Gas Lift
Seat Plate
Plastic Covers
Pre-assembled Seat and Back
Cushions w /arms
2-1/4” Screws
1” Screws
1-1/4” Screws
Back Flap
Back Support Plate
Wrench
Hardware Pack
5
1
1
1
1
2
1
2
2
4
1
1
1
1
11625
11709
11626
11708
11601
H
11710**
H
H
H
~
~
H
11711
PARTS LIST
ASSEMBLY INSTRUCTIO
NS
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire